Zum Hauptinhalt wechseln
Hilfe

Casio Cassiopeia E-125 Motherboard Replacement

Falsche Werkzeuge

Falsche Werkzeuge

Hilf dabei, diese Anleitung zu verbessern, indem du die richtigen Werkzeuge auf den Bildern oder im Text verwendest.

Benötigt Bessere Bilder

Benötigt Bessere Bilder

Schönere Fotos werden diese Anleitung verbessern. Trage dazu bei, indem du die Alten bearbeitest oder Neue aufnimmst und hochlädst!

Fehler in den Markups

Fehler in den Markups

Diese Anleitung benötigt bessere Markups. Hilf aus, indem du sie korrigierst oder einige Markup-Anmerkungen erstellst.

Benötigt Mehr Bilder

Benötigt Mehr Bilder

Einige Bilder mehr würden die Vorgehensweise in dieser Anleitung deutlich klarer machen.

Bessere Einleitung

Bessere Einleitung

Verbessere diese Anleitung, indem du die Einleitung vervollständigst oder überarbeitest.

This guide will show you how to replace the motherboard.

  • Autor: Ryan Fernandez
  • Geschätzte Zeit: 30 - 40 Minuten
  • Schwierigkeitsgrad: Moderat
Abschnitte
Werkzeuge
Werkzeuge (fortgesetzt)

Schritt 1 Motherboard  ¶ 

Locate the small grey ribbon cable towards the bottom of the device. It should be located above the battery slot. Pinch both sides of the ribbon cable and pull it out.

Schritt 1 Motherboard  ¶ 

  • Locate the small grey ribbon cable towards the bottom of the device. It should be located above the battery slot. Pinch both sides of the ribbon cable and pull it out.

Schritt 2  ¶ 

Locate the multicolored wire on the motherboard near the battery compartment. Pull on the wire by the base and lift to remove.

Schritt 2  ¶ 

  • Locate the multicolored wire on the motherboard near the battery compartment. Pull on the wire by the base and lift to remove.

Schritt 3  ¶ 

Use the Phillips #00 Screwdriver to remove the two screws from the green circuit board on the back case.

Schritt 3  ¶ 

  • Use the Phillips #00 Screwdriver to remove the two screws from the green circuit board on the back case.

Schritt 4  ¶ 

Remove the the three screws on the motherboard that are shown using the Phillips #00 Screwdriver.

Schritt 4  ¶ 

  • Remove the the three screws on the motherboard that are shown using the Phillips #00 Screwdriver.

Schritt 5  ¶ 

Caution: do not break ribbon cables from the motherboard because this may cause damage to your device.

Schritt 5  ¶ 

  • Caution: do not break ribbon cables from the motherboard because this may cause damage to your device.

  • Flip the motherboard towards the front cover to expose the ribbon cables underneath.

Schritt 6  ¶ 

Locate the two ribbon cables on the motherboard. Select one to remove first and then pinch either side of it and pull out to remove the ribbon cable. Do the same for the second. Locate the two ribbon cables on the motherboard. Select one to remove first and then pinch either side of it and pull out to remove the ribbon cable. Do the same for the second.

Schritt 6  ¶ 

  • Locate the two ribbon cables on the motherboard. Select one to remove first and then pinch either side of it and pull out to remove the ribbon cable. Do the same for the second.