Zum Hauptinhalt wechseln
Hilfe

Fujifilm FinePix 4700 Zoom Motherboard Unit Replacement

Benötigt Bessere Bilder

Benötigt Bessere Bilder

Schönere Fotos werden diese Anleitung verbessern. Trage dazu bei, indem du die Alten bearbeitest oder Neue aufnimmst und hochlädst!

Bessere Einleitung

Bessere Einleitung

Verbessere diese Anleitung, indem du die Einleitung vervollständigst oder überarbeitest.

This guide will help you remove the motherboard unit on the camera. The unit consists of the motherboard, speaker, screen, and battery compartment.

  • Autor: Sarthak Patel
  • Geschätzte Zeit: 15 Minuten
  • Schwierigkeitsgrad: Moderat

Schritt 1 Motherboard Unit  ¶ 

Pull gently when removing the speaker so you don't rip the wire attached to it.

Schritt 1 Motherboard Unit  ¶ 

  • Pull gently when removing the speaker so you don't rip the wire attached to it.

  • Use the tweezers to grab the speaker (located on left side of the camera) and pull straight up.

  • The speaker will still be connected to the motherboard, but it will not be attached to the front case.

Schritt 2  ¶ 

Use the tweezers to pull gently on the small orange ribbon, located in upper left hand corner near the flash, to remove the square insert.

Schritt 2  ¶ 

  • Use the tweezers to pull gently on the small orange ribbon, located in upper left hand corner near the flash, to remove the square insert.

Schritt 3  ¶ 

Use your fingers to slowly pull the flash straight up.

Schritt 3  ¶ 

  • Use your fingers to slowly pull the flash straight up.

  • The step may take a little jiggling.

Schritt 4  ¶ 

Do not fully separate the motherboard unit from the front cover. There is still a ribbon attached and it will rip. Slightly separate the front cover from the motherboard unit (which consists of the motherboard, speaker, screen, and battery compartment).

Schritt 4  ¶ 

  • Do not fully separate the motherboard unit from the front cover. There is still a ribbon attached and it will rip.

  • Slightly separate the front cover from the motherboard unit (which consists of the motherboard, speaker, screen, and battery compartment).

  • Rotate the bottom portion of the motherboard unit (the screen and battery compartment) over the lens unit.

Schritt 5  ¶ 

Use your fingers to remove the tripod mount.

Schritt 5  ¶ 

  • Use your fingers to remove the tripod mount.

Schritt 6  ¶ 

Be gentle when undoing the ribbon clips. They break easily. Gently stick the spudger under the ribbon clips and lift them up. Use the tweezers to pull both ribbons out of the ribbon clips.

Schritt 6  ¶ 

  • Be gentle when undoing the ribbon clips. They break easily.

  • Gently stick the spudger under the ribbon clips and lift them up.

  • Use the tweezers to pull both ribbons out of the ribbon clips.

  • The motherboard unit should now be free from the rest of the camera.