Zum Hauptinhalt wechseln

Aufpolierte Version des iPhone 3GS mit schnelleren Verarbeitungsgeschwindigkeit. Die Reparatur geht ähnlich wie beim 3G vonstatten und braucht nur einfache Schraubendreher und Hebelwerkzeuge. Modell A1303 mit 16 oder 32 GB Kapazität mit schwarzer oder weißer Kunststoffrückseite.

1500 Fragen Alle anzeigen

No antenna Service after opening iPhone

does anyone know where the antenna is on the iPhone 3GS, broke my screen and when i was changing it i took the board and battery out to look it it all, and know im getting no service, any ideas?

Diese Frage beantworten Ich habe das gleiche Problem

Ist dies eine gute Frage?

Bewertung 1
Einen Kommentar hinzufügen

9 Antworten

Hilfreichste Antwort

you must have disconnected the antenna. its in the upper left corner.

see the diagram and the logic board in the teardown.

step 11:

iPhone 3GS Teardown

War diese Antwort hilfreich?

Bewertung 1
Einen Kommentar hinzufügen

hi,

in my case both antennas (bottom right und up left) are connected. WLAN is ok, but GSM/UMTS is bad....any idea?

War diese Antwort hilfreich?

Bewertung 0
Einen Kommentar hinzufügen

Having the same problem... Any solution yet?

War diese Antwort hilfreich?

Bewertung 0
Einen Kommentar hinzufügen

Can anyone advise how to reconnect the antenna?

I replaced the battery and now have "no signal" and cannot see how to reconnect the antenna?

Is it under location 7 - the "do not remove" paper?

War diese Antwort hilfreich?

Bewertung 0

1 Kommentar:

I had the same problem after installing a larger battery.

Re-installed the previous battery and took it back to the Apple store. They advised it was a modem problem and replaced the iPhone.

Be sure to replace the "do not remove" paper and don't leave any trace of opening the iPhone.

Also, when replacing the battery, ensure number 7 is secure and ensure the two metal tips sticking up (near number 7) are touching the side casing.

Be very careful when removing the board and putting it back.

I was extremely careful when doing the battery replacement but didn't view those two tips when removing the board. Before removing, check to see where the two tips are touching.

Anyone with further experience?

von

Einen Kommentar hinzufügen

I have the same problem with my 3GS after replacement of the battery, now just goes from Full service to then sometimes NO Service to Searching for service..... I have checked all connectors and even traced with a Multi-meter the contacts between the GSM/ UTMS antenna and everything is fine. Anyone know what the problem could be? There are NO cracks or missing components e.g. RF inductors or other parts missing. Anyone have an idea?

War diese Antwort hilfreich?

Bewertung 0
Einen Kommentar hinzufügen

I have this same problem. I'm not sure where those two gold points are supposed to touch. They came out when I pried on up on the bezel too far. Can anyone help?

War diese Antwort hilfreich?

Bewertung 0
Einen Kommentar hinzufügen

Taken a look at this. I found this online, but haven't had time to check it out.

http://cybermog.wordpress.com/2010/04/29...

War diese Antwort hilfreich?

Bewertung 0
Einen Kommentar hinzufügen

I have the same problem with my iPhone 3gs. The link shared in there is for iPhone 3G. Has anyone fixed No signal issue with 3GS?

War diese Antwort hilfreich?

Bewertung 0
Einen Kommentar hinzufügen

there is a little spring thingy on the bottom right, just below the do not remove sign. make sure it's well connected...

it kind of clicks when it's in place

War diese Antwort hilfreich?

Bewertung 0
Einen Kommentar hinzufügen

Antwort hinzufügen

kael wird auf ewig dankbar sein.
Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 22,683