Rep: 7
2
I make this topic so other with the same problem, can find the solution here.
iPhone 5 not searching for network. Only says No service.
I had this problem when i changed powerflex on iphone 5. The screwdriver slipped and it then wouldnt find signal.
I found out this was missing:
After soldering this it had fine signal again.
Ist dies eine gute Frage?
Rep: 9,6 Tsd.
16
15
16
ive located the component, its a 70-OHM-300MA resister. it is part of the phones RF TRANSCEIVER DECOUPLING.
War diese Antwort hilfreich?
Rep: 11
1
Hi after seeing your post i try to identify if my problem is the same .
Can you explain if there is a components at the place you solder ? Mine looks like none. But before solder i just want to make sure.
So you make a bridge between the two solder point ?
thanks
War diese Antwort hilfreich?
Rep: 7
2
The one i fixed had broke the resistor clean off, so i just soldered between the 2 points. Try to get a magnifier to see closely if it is missing.
War diese Antwort hilfreich?
Rep: 11
1
Hi thanks for your answer. I take a magnifier and see a gap between two pin next to the screw hole.
is this correct or is this the resistor behind this two pin ?
I will try to take a photo but it's not easy...
Thanks a lot..
War diese Antwort hilfreich?
Rep: 11
1
To illustrate see the image. This is the 1 or the 2 ?
Thanks
War diese Antwort hilfreich?
Rep: 7
2
It is the one closest to the screw hole. So it is number 1.
War diese Antwort hilfreich?
Rep: 11
1
I try but it's very difficult to sold...
War diese Antwort hilfreich?
Rep: 11
1
Did but nothing change... Thanks again for your advice. I appreciate. Hope your solution work for another.
Have a good day /night
War diese Antwort hilfreich?
Letzte 24 Stunden: 0
Letzte 7 Tage: 0
Letzte 30 Tage: 0
Insgesamt: 210
