Repariere deine Sachen Community Store

MacBook Pro Modelle mit 13'' Retina Displays ab dem Jahr 2012.

4674 Fragen Alle anzeigen

Einstellungen

Black screen, until lit is almost closed

Hello iFixit.

I replaced my screen on my Macbook Pro, and when i set the new screen in and power on, I hear the startup sound, but just black screen. When I try to close the lit, 2cm from totally closed it turns on, and then works fine.

I have tried:

Resetting NVRAM / PRAM

Resetting the “SMC”

Start up into Safe Mode

Edit:When i log in and try to put into sleep mode, it works fine. It seems like it's only on the login screen.

Beantwortet! Antwort anzeigen Ich habe das gleiche Problem

Ist dies eine gute Frage?

Ja Nein
Bewertung 0
Einen Kommentar hinzufügen

1 Antwort

Filtern nach:
Am hilfreichsten Neueste Älteste
Gewählte Lösung

Einstellungen

Could be a bad LCD cable or a faulty LCD panel ribbon (sometimes the picture can cut out at certain angles), I would recommend trying the old screen to see if it is fine. Also try running a magnet along the left side of the palmrest (to the left of the keyboard along the top), to see if the screen tries to turn on. When the Macbook detects a magnet in this area, it thinks the lid is shut (so it will turn the screen off), this could be the problem?

I would most likely say a faulty LCD assembly though. Try your old one and see if it is fine.

War diese Antwort hilfreich?

Ja Nein
Bewertung 1

7 Kommentare:

I have tried the old screen, and it's the same.

When i run a magnet at the ESC button the screen starts up as normal.

von

And on normal use it works just fine.

von

I would recommend testing the screen when not screwed into the palmrest area, to see if it works fine. Sounds like an issue with the hall sensor/sleep sensor.

von

I tried the flash light test, and it showed my screen.

von

Sorry, do you mean you put a flash light to the screen and could see a dark image? There is a signal on the logic board SMC_LID which dims the screen when it thinks the lid is shut. I think this part of the circuit is the issue (or magnet interference), but I am not sure without looking at it.

I would recommend taking it somewhere who can look at this and professionally diagnose the logic board, it sounds like that is where the fault is.

von

2 weitere Kommentare anzeigen

Einen Kommentar hinzufügen

Antwort hinzufügen

Per Eckholdt wird auf ewig dankbar sein.
Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 6

Insgesamt: 627