Repariere deine Sachen Community Store

Das Apple iPhone 5s wurde am 10. September 2013 angekündigt. Die Reparatur dieses Geräts ist ähnlich wie bei den Vorgängermodellen und erfordert Schraubendreher und Hebelwerkzeuge. Verfügbar mit GSM oder CDMA mit 16, 32 oder 64 GB in silber, gold und space grau.

3530 Fragen Alle anzeigen

Einstellungen

iPhone 5s crashing after battery change

Hi there

I was in the believe that a batery change was the only problem with the iphone 5s when it turned hot and said it has to cool down before i could use it again. I changed the battery just to find out the phone crashes all the time, the phone boots up some times when pluged into charger, and some times i have to hold power and home button to get it boot up. Do anyone have a clue to what issues i´m facing?

Regards from Denmark

Beantwortet! Antwort anzeigen Ich habe das gleiche Problem

Ist dies eine gute Frage?

Ja Nein
Bewertung 1
Einen Kommentar hinzufügen

1 Antwort

Filtern nach:
Am hilfreichsten Neueste Älteste
Gewählte Lösung

Einstellungen

Hello Carsten. If you are confident that you have used a known-good quality replacement battery, then I would ask where is the excess heat on your device?

There are 4 thermistors on the logic board (forehead, RCAM, Baseband & CPU) so if anyone of those areas detects excess heat, it will send you that error message. So wherever the heat is, that is probably where the problem is. It is unlikely that the thermistors themselves have failed although it is not impossible. More than likely, there is high current going through one of those areas due to a partial or full short caused by a bad component or module.

To eliminate any issues with the camera or front screen (forehead), remove the logic board and connect only the charge port and battery and see if iTunes sees the device. Then progressively add the screen (no fcam), home button, fcam, rcam etc until the message shows up. If it is in the baseband or or CPU area, the message will appear quickly.

Your problem will either be modular (i.e. camera) or logic board.

War diese Antwort hilfreich?

Ja Nein
Bewertung 3

2 Kommentare:

Hi Minho

And thanks for your answer. I have noticed that the heat is coming from the right side on the midle of the phone.

von

On the front of the device or back? The front mid-section corresponds to the CPU but on the back it is the PMIC. Once it gets hot enough it's hard to tell the difference but with the logic board removed, you should be able to tell.

von

Einen Kommentar hinzufügen

Antwort hinzufügen

Carsten wird auf ewig dankbar sein.
Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 1

Insgesamt: 188