Repariere deine Sachen Community Store

Das iPhone 6 mit dem 4,7 Zoll Display ist die kleinere Version des iPhone 6 Plus und kam am 19. September 2014 auf dem Markt. Es hat die Modelnnummern A1549, A1586 und A1589.

4994 Fragen Alle anzeigen

Einstellungen

What causes these LCD marks?

Hello,

I have replaced a iphone 6 screen and the frame. After putting everything togheter i notice this mark on the LCD. The screen is a little stressed. Did i do this damage when repairing the device or is there something wrong with the screen? I have repaired a new screen today, and i notice the same thing, but in very small amount.

You can only see it clearly when the screen is compeltely white, so it is not a very big problem.

The screens are high quality copy screens. (MiC)

Thanks!

Block Image

Block Image

Beantwortet! Antwort anzeigen Ich habe das gleiche Problem

Ist dies eine gute Frage?

Ja Nein
Bewertung 0
Einen Kommentar hinzufügen

2 Antworten

Filtern nach:
Am hilfreichsten Neueste Älteste
Gewählte Lösung

Einstellungen

The small white area is caused by excessive pressure. Remove the screen from the housing but keep it connected. If the mark is still there, then it may be a defective replacement screen.

The screen should not be stressed when properly installed. Look for debris that may be causing this.

War diese Antwort hilfreich?

Ja Nein
Bewertung 3

3 Kommentare:

Thank you Minho. When removing the screen the mark goes away. I have tried removing the LCD shield plate and clean for debris. It is better now, but the mark is still there. I am not sure what the cause might be. What i noticed is that when i apply pressure to the LCD plate, the white area appears. So it must have something to do with that. But as i said, the area behind the shield looked really clean.

von

It doesn't take much. Inspect it again...there must be something somewhere causing this.

von

After a lot of cleaning/reassembling i got the worst of it away. It seemed to me some sand/small corns on the screen flex. Scraped that away and it worked again

von

Einen Kommentar hinzufügen

Einstellungen

That could be pressure, heat, water damage or bad display manufacturing(vacuum related usually)

War diese Antwort hilfreich?

Ja Nein
Bewertung 0
Einen Kommentar hinzufügen

Antwort hinzufügen

Iver wird auf ewig dankbar sein.
Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 2

Letzte 30 Tage: 2

Insgesamt: 2,270