Rep: 13
2
1
See photo:
This is a connector for an Ipad Pro charging port. I am replacing this however, when I took the old one off half of this pad came off..
Can I solder to this pad with majority of it gone or do I have to run a jumper? I am just learning so please have some mercy. Thank you!
Ist dies eine gute Frage?
Rep: 782,3 Tsd.
1,1 Tsd.
893
2,3 Tsd.
@smitty1510 yes you can but you better be good at it. No room for fudging and you only have one chance.
War diese Antwort hilfreich?
@oldturkey03 I need to run a jumper... No schematic or BV available for this model. Not on ZXW either... Any Ideas? How can I find out where to run the jumper?
@smitty1510 there is no way unless you have the schematic.
Letzte 24 Stunden: 0
Letzte 7 Tage: 0
Letzte 30 Tage: 3
Insgesamt: 108
