Repariere deine Sachen Community Store

A washer series by Maytag with a low rate of customer satisfaction and a high rate of failure. These washers have the model numbers MVWB300xxx or MVWX300xxx.

213 Fragen Alle anzeigen

Einstellungen

Won't run a cycle after replacing the lidlock.

Bravos 300 top-load washer: MVWB300WQ0

After replacing the lidlock, I buttoned everything back up and plugged the washer in. Aha! Regular startup screen. Chose the drain and spin cycle, display showed 14min as usual. Pressed start. Heard the magnetic lidlock engage and the light came on. Cycle never began. I then pushed cancel. After that, any button I push, or turn of the knob , causes a beep. Display no longer showing anything. I unplugged the washer, waited 5 min and tried again. Same scenario.

I've checked several sites and looked through all of the appliance assistant pages. Nowhere can I find what the consistent beeping signifies. Anyone know?

Diese Frage beantworten Ich habe das gleiche Problem

Ist dies eine gute Frage?

Ja Nein
Bewertung 0
Einen Kommentar hinzufügen

1 Antwort

Filtern nach:
Am hilfreichsten Neueste Älteste
Hilfreichste Antwort

Einstellungen

Hi @momac

The beep is an indication that the lid is not detected as being closed, even though you've heard the lock operate.

Here's the tech sheet for the washer.

Go to Test #8 Lid Lock on p.6 to check if the lid lock, lid lock circuit is OK

War diese Antwort hilfreich?

Ja Nein
Bewertung 1

3 Kommentare:

Thanks jayeff. I'll give it a try.

von

Where can I get a diagram to reference the p# connectors?

von

@momac

See p.15 of the tech sheet.

Usually the connector pin number is shown on the board, either by the number 1 at one end of the connector or perhaps an arrowhead

von

Einen Kommentar hinzufügen

Antwort hinzufügen

Tof McWilliams wird auf ewig dankbar sein.
Seitenaufrufe:

Letzte 24 Stunden: 2

Letzte 7 Tage: 5

Letzte 30 Tage: 12

Insgesamt: 103