Aktuelle Version von:
Alexander ,
Text:
| there is a little gear which can get out from it place in time. Check its position and if its moved - use a glue to hold it at place. |
| |
| [image|1326756] |
|
|
| here is an example of wrong position of the gear:
|
|
|
| here is an example of wrong position of the gear:
|
| [image|1328634]
|
| |
| If you can't figure out where is the gear in a printer - look at the bottom right corner of the picture: [image|1669708] |
| |
| '''If you need a replacement part:''' |
| |
| * google tne next text "pinion gear 10T 0.3M bore 1.5mm"; |
| * also spare parts for RC helicopters can be applied, for example MH-BP031015
|
Status:
open
Bearbeitet von:
Alexander ,
Text:
| there is a little gear which can get out from it place in time. Check its position and if its moved - use a glue to hold it at place. |
| |
| [image|1326756]
|
| |
| |
| here is an example of wrong position of the gear: |
| [image|1328634]
|
Status:
open
Ursprünglicher Beitrag von:
Alexander ,
Text:
there is a little gear which can get out from it place in time. Check its position and if its moved - use a glue to hold it at place.
[image|1326756]
Status:
open