Zum Hauptinhalt wechseln

Repariere deine Sachen

Recht auf Reparatur

Werkzeug & Ersatzteile

Hilfe

Ursprünglicher Beitrag von: TCRS Circuit ,

Text:

Your going to have to pull it from a donor board. Use lots of flux, and heat the donor board from the bottom from directly below the connector. You will need a beefy hot air station like the Quick 861DW. To solder it, your going to put some leaded solder on the pads, wick it away, add new solder and flux,  place the connector then bottom heat again on the patient board.

There is nothing easy about this. It is a real pain

Status:

open