Zum Hauptinhalt wechseln

Repariere deine Sachen

Recht auf Reparatur

Werkzeug & Ersatzteile


Ursprünglicher Beitrag von: ldsishere ,


I repaired a DV2810us following the method described by Adolfo and it worked great.  After covering the board in aluminum foil and only exposing the video/chipset chip, I used the heat gun on low ~700F for about 40 seconds.  Hellus also had a good suggestion that I did and that was to replace the thermal pad with a copper shim.  A very, very thin layer of AS5 finished it up.

IMHO I would not run any kind of processor with out a heat sink since you cannot control the temps and any damage will start internally and it will be too late by the time you see it.