Zum Hauptinhalt wechseln
Hilfe

Aktuelle Version von: Sam Goldheart ,

Titel:

Broke capacitor legs while repairing logic board, can it be saved?

Text:

During removal of bad caps a few spots had a leg of the capicitor break off inside the motherboard. There is not enough leg to grab onto. I have even cut them flush to the motherboard with nail clippers in a botched attempt to clear them.

I am using a radioshack (RS) 30 watt soldering iron and a RS 45 watt de-soldering (DS) iron.

I opened the other holes of excess solder by holding the hot de-soldering iron on the backside of the motherboard and pushing a small safety pin through from the frontside. This method was difficult and required some time and force. This was not effective at freeing the broken legs.

What are my alternatives?

Is there a way to use these blocked holes as is?

I believe the equipment I have used is may be too low in wattage and made my work more difficult than necessary. Would a more powerful iron make it possible to clear the holes?

Should I put it under a drill press and try to drill them out?

Gerät:

-iMac G5 model A1058
+iMac G5 17" Model A1058

Status:

open

Akzeptierte Antwort:

84759

Bearbeitet von: Dan ,

Titel:

Broke capacitor legs while repairing logic board, can it be saved?

Text:

During removal of bad caps a few spots had a leg of the capicitor break off inside the motherboard. There is not enough leg to grab onto. I have even cut them flush to the motherboard with nail clippers in a botched attempt to clear them.

I am using a radioshack (RS) 30 watt soldering iron and a RS 45 watt de-soldering (DS) iron.

I opened the other holes of excess solder by holding the hot de-soldering iron on the backside of the motherboard and pushing a small safety pin through from the frontside. This method was difficult and required some time and force. This was not effective at freeing the broken legs.

What are my alternatives?

Is there a way to use these blocked holes as is?

I believe the equipment I have used is may be too low in wattage and made my work more difficult than necessary. Would a more powerful iron make it possible to clear the holes?

Should I put it under a drill press and try to drill them out?

Gerät:

iMac G5 model A1058

Status:

open

Akzeptierte Antwort:

+84759

Ursprünglicher Beitrag von: Dan ,

Titel:

Broke capacitor legs while repairing logic board, can it be saved?

Text:

During removal of bad caps a few spots had a leg of the capicitor break off inside the motherboard. There is not enough leg to grab onto. I have even cut them flush to the motherboard with nail clippers in a botched attempt to clear them.

I am using a radioshack (RS) 30 watt soldering iron and a RS 45 watt de-soldering (DS) iron.

I opened the other holes of excess solder by holding the hot de-soldering iron on the backside of the motherboard and pushing a small safety pin through from the frontside. This method was difficult and required some time and force. This was not effective at freeing the broken legs.

What are my alternatives?

Is there a way to use these blocked holes as is?

I believe the equipment I have used is may be too low in wattage and made my work more difficult than necessary. Would a more powerful iron make it possible to clear the holes?

Should I put it under a drill press and try to drill them out?

Gerät:

iMac G5 model A1058

Status:

open