2008 Dodge Avenger SE
2008 ACCESSORIES & EQUIPMENT Frame & Bumpers Avenger & Sebring
2008 ACCESSORIES & EQUIPMENT Frame & Bumpers Avenger & Sebring
BUMPERS
SPECIFICATIONS
IORQUE SPECIFICATIONS BUMPERS
IORQUE SPECIFICATIONS
| DESCRIPTION | Ft. Lbs. | |
|---|---|---|
| Rear bumper reinforcement attaching nut | 28 | 21 |
| Front Crossmember to cradle bolts (3 | 50 | 41 |
| Front suspension crossmember frame rail torque boxes attaching bolts | 135 | 100 |
| Front suspension crossmember attaching_front and rear_ | 55 | |
| ForelAft crossmember anti roll through bolt | 50 | 37 |
| Radiator_support crossmember attaching bolts_ | 115 | 85 |
| Shear bracket fasteners | 55 | 41 |
Table Caption: This table lists torque specifications, in foot-pounds, for various automotive components, primarily related to front and rear bumper reinforcements, suspension crossmembers, and related brackets.
CLOSEOUT-LOWER FASCIA FRONT REMOVAL
- 1 . Remove fasteners (5) to lower closeout.
com
2008 Dodge Avenger SE
2008 ACCESSORIES & EQUIPMENT Frame & Bumpers Avenger & Sebring
Fig 2: Identifying Closeout-Front Lower Fascia Courtesy of CHRYSLER LLC
- 2 Remove pins (1) to lower closeout. push
- 3 Remove the front lower fascia.
INSTALLATION
Fig 3: Identifying Lower Fascia Courtesy of CHRYSLER LLC
- Install closeout panel (1) onto fascia (3) push pins (2) and screws (4).
- 2 Install fasteners (5).
FASCIA-FRONT REMOVAL
com
2008 Dodge Avenger SE
2008 ACCESSORIES & EQUIPMENT Frame & Bumpers Avenger & Sebring
- Remove air inlet pin (4) and air-box fastener (2) push
- 2 Remove pins (2) and fascia fasteners (1) from grille. grille push
com
2008 Dodge Avenger SE
2008 ACCESSORIES & EQUIPMENT Frame & Bumpers Avenger & Sebring
- 3_ Lift vehicle and on both the left and right remove two splash shield fasteners (1) and eight pins.
- 4 Remove splash shields from vehicle.
- 5 Remove closeout panel. See REMOVAL
- 6 Slide fascia forward disengaging from pins. push
- 7 . If equipped, disconnect lamp connectors. fog
- 8 Disconnect the side marker electrical connectors . lamp
- 9 Remove fascia from vehicle.
INSTALLATION
~
com
2008 Dodge Avenger SE
2008 ACCESSORIES & EQUIPMENT Frame & Bumpers Avenger & Sebring
- 1 . Raise vehicle.
- 2 Raise fascia up to vehicle and connect connectors if equipped. fog lamp
- 3 Connect the side marker lamp electrical connectors.
- 4 Slide fascia into push pins ensuring proper seat.
- 5 Install closeout panel fasteners and pins. See INSIALLATION push
- 6 Install right and left splash shield fasteners and push pins.
- 7 Lower vehicle.
com
2008 Dodge Avenger SE
2008 ACCESSORIES & EQUIPMENT Frame & Bumpers Avenger & Sebring
- 8 Place onto fascia. grille
- 9 Install pins (2) and fascia fasteners (1 ). Refer to INSIALLAIION grille push
- Install air box inlet pin (4) and fastener (2) push
FASCIA-REAR
REMOVAL
AVENGER
com
2008 Dodge Avenger SE
2008 ACCESSORIES & EQUIPMENT Frame & Bumpers Avenger & Sebring
- Open decklid.
- 2 Remove upper fascia push (1) pins
