Replacing turn signal/wiper/cruise control combination switch
I have the replacement parts, but need some information in replacing the old one.
Ansicht:
Bestätigte AbstimmungenJeder mit mehr als 20 Reputationspunkten kann problematische Kommentare und Beiträge melden.
Details anzeigen
Rep: 1
Veröffentlicht:
I have the replacement parts, but need some information in replacing the old one.
Rep: 39 Tsd.
Veröffentlicht:
Simply pull off the rubber cover, using a flat screw driver to help if needed. You will then see a bolt that holds the assembly in place, and a few screws that hold on wires. Remove those, and then unplug the wire harness plug. With all that done you should be able to pull out the old switch. Installing the new switch is just the reverse of this.
Ups! Ich will meine Meinung nochmal ändern.
Erweitern / Reduzieren
Bestätigen
Positiv
Ablehnen
Negativ
Hilfe öffnen
Seite 1 von 1