Anleitungen, zu denen ich beigetragen habe
Antwort auf „How do I develop the picture?”Step 1: Pull the white tab all the way out of the camera to expose the yellow tab labeled “pull” (Note: if you can see both a yellow and white tab, pull the yellow tab. Never pull the white tab when both are exposed, as this can ruin the entire film pack) Step 2: Pull the yellow tab straight out of the camera without hesitation and with a little bit of speed. This will start the development process. Step 3: Make sure to hold the tab only by the yellow tip and do not touch the white paper (don't bend it or shake it either!). Allow photo to develop for recommended time. Step 4: After the full development time, quickly pull the print away from the white paper, starting near the yellow tab. Do not start from the other end, this will cause developer’s chemicals to leak on your fingers. Do not touch the face of the print. Step 5: Color photos need to be mounted and black and white photos should be coated. This will preserve them longer.
Antwort auf „How do I load a film pack?”Step 1: Set the film speed to 75 for color photos and 3000 for black and white. Step 2: Push the back door latch to open the door Step 3: Hold the film pack by the edges, being careful not to squeeze the pack. Make sure the printing on the safety cover faces the lens. Step 4: Push the closed end of the pack under the door hinge and push the pack down into the camera, where it should snap into place. Step 5: Tightly shut the door, making sure that the black paper tab sticks out of the slot. Step 6: Grip the tab firmly and pull the safety cover out of the camera completely. And you're ready to take pictures!