Zum Hauptinhalt wechseln

Reemplazo del botón de encendido y volumen

Hinweis: Du bearbeitest eine grundständige Anleitung. Alle Änderungen, die du vornimmst, betreffen auch die Anleitung, die diese beinhaltet.

Englisch
Spanisch
Schritt 19
iPad 2 GSM Volume and Power Button Cable Replacement: Schritt 0, Bild 1 von 3 iPad 2 GSM Volume and Power Button Cable Replacement: Schritt 0, Bild 2 von 3 iPad 2 GSM Volume and Power Button Cable Replacement: Schritt 0, Bild 3 von 3
  • To remove the upper component board you will be pulling gently on its cable while lifting it up enough to clear the battery, but not high enough to scrape against the rear case. Go slowly and carefully.

  • Insert the tip of a spudger under the upper component board to lift it slightly.

  • Pull the board up and out of the space between the battery and the rear case bezel.

  • Remove the upper component board.

  • On reassembly, you'll want to reconnect the GPS antenna cable at this point. Use tweezers and work carefully.

Para retirar la placa de componentes superior, tira suavemente de su cable mientras la levantas lo suficiente como para dejar libre la batería, pero no lo suficiente como para rozar la caja trasera. Ve despacio y con cuidado.

Introduce la punta de un spudger bajo la placa de componentes superior para levantarla ligeramente.

Tira de la placa hacia arriba y sácala del espacio entre la batería y el bisel de la caja trasera.

Retira la placa de componentes superior.

En el reensamblaje, querrás volver a conectar el cable de la antena GPS en este punto. Utiliza pinzas y trabaja con cuidado.

Deine Beiträge sind lizenziert unter der Open-Source Creative Commons Lizenz.