Ionic Breeze Disassembly

Hinweis: Du bearbeitest eine grundständige Anleitung. Alle Änderungen, die du vornimmst, betreffen auch die Anleitung, die diese beinhaltet.

Englisch

Deutsch

Schritt 4 übersetzen

Schritt 4

Desolder Power Cable

Photos depict where to desolder the power cables connection points. Remove any hot glue that may be holding down the cables. These devices are a little seasoned so the glue should not be hard to remove by hand.
I found it easiest to use the base to prop up the body, the half of the housing that the electronics typically reside in, in order to get a good angle at removing the solder. I'm sure it can be done on its side but lets work smarter, not harder here.
Remember to pull the ground cable completely through the PCB. We will re-thread it back through during the reassembly process.
Remember, the base is not attached at this point. Don't knock the Ionic Breeze over while it's in an upright position with it's internal components exposed.

Deine Beiträge sind lizenziert unter der Open-Source Creative Commons Lizenz.