Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
This page will guide you on the replacement of the battery on your 360fly 4K camera.
Was du brauchst
-
-
Flip the camera upside down and peel off the two plastic screw covers with the metal spudger to reveal the screws.
-
-
-
Remove the two 5mm T4 screws from the bottom of the camera with a t4 screw driver.
-
-
-
-
Gently pry the plastic ring from around the charging plate with the metal spudger.
-
Remove the outside shell by pressing against the center of the charging plate and pulling the bottom shell away from the top shell.
-
-
-
Remove the five 2mm T4 screws and pull off the charging plate assmebly with the t4 screw driver.
-
-
-
Gently pry the plug off the port on the circuit board with a plastic opening tool.
-
Remove the four 2mm T4 screws and take off the circuit board with a T4 screw driver.
-
-
-
Remove the five 4mm T4 screws around the battery assembly with a t4 crew driver.
-
Lift the battery assembly and gently pry the plug out of its port on the board below with a plastic opening tool.
-
Press the battery from the back of the battery assembly to remove it with a plastic opening tool until the glue releases the battery.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Nutzer:innen haben diese Anleitung absolviert.
4 Kommentare
Wich one battery Can I use to replace It?
Where can i purchase a battery
I would like to purchase a 360 fly battery