Einleitung
This guide will show you how to locate, remove, and replace the buttons on the AT&T NVG510 modem. In the event that a button becomes stuck or your router becomes unresponsive when you press a button, you may need to replace it. This guide does require you to be able to operate a soldering iron carefully.
Was du brauchst
-
-
Place the router on one side so that the rubber stands are facing upward.
-
Remove the stands from the left corners only, relative to the AT&T logo if facing upright.
-
-
In diesem Schritt verwendetes Werkzeug:Flathead 3/32" or 2.5 mm Screwdriver$5.49
-
Remove two screws using a 2.0 flathead screwdriver.
-
-
-
-
Pry open the case to reveal the board.
-
Take out the one screw located on the center-right area of the board.
-
-
-
Locate the buttons to the right of the yellow ports along the edge of the board.
-
-
-
Locate the silver points that connect the buttons to the board.
-
To release the buttons, use a soldering iron to heat up and melt the silver connecting points.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.