Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
How to remove and replace the monitor on the Apple Powerbook 5300
Was du brauchst
-
-
Position the Powerbook towards you with the monitor closed.
-
Press the battery removal latch located on the right side of the front panel.
-
Gently slide the battery out.
-
-
-
Turn the laptop over and remove the three T8 torx screws from the bottom panel.
-
-
-
Turn the laptop back over and open the monitor.
-
With the monitor facing towards you, gently pull up on the keyboard panel from the bottom.
-
-
-
Remove side panels by pulling up and towards the rear of the laptop. Remove the two torx #8 screws.
-
-
-
-
Disconnect the ribbon cable from the logic board. Note the cable is twisted around the monitor hinge, so do not pull up.
-
-
-
Use a pin to pry up the Powerbook 5300 and Macintosh logos to reveal two torx #8 screws. Remove these screws.
-
-
-
Use a wedge tool to pry open the two halves of the monitor assembly. Lift the top half away from the bottom half.
-
-
-
Unscrew the three torx #8 screws above and below the white paper backing. Remove the tape and peel back the paper backing to access the screws below.
-
-
-
All monitor components should be visible. The transformer board is pictured on the left. The speaker is connected to this board and runs down through the paper housing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Nutzer:innen haben diese Anleitung absolviert.