Einleitung
This guide will explain how to remove and replace the speakers on the Beats Pill 1.0. This will require almost complete disassembly of the device.
Was du brauchst
-
-
Using the spudger, create space between the speaker covers and then remove.
-
On the underside of the device, remove the rubber stand with the BeatsPill logo on it.
-
Using an ESD-safe Phillips #0 screwdriver, remove the four screws that were underneath the rubber stand.
-
-
-
Remove the two screws with a Phillips #0 screwdriver.
-
Slowly remove the center band and two clip rings until the adhesive separates. Sit to the side the clip rings and the center band
-
-
-
Use the spudger to pry the device apart along its seam, starting in the middle.
-
Open the device to separate the front and back panels.
-
-
-
Carefully remove the yellow, red, black, and white wires from the motherboard.
-
-
-
-
Carefully remove the black and red NFC sensor wires.
-
-
-
Carefully remove the control cables (4 black, 1 red).
-
-
-
Remove the four 6 mm screws holding the band in place using a Phillips #0 screwdriver.
-
-
-
Remove the three 9 mm screws from motherboard and rubber stopper using a Phillips #0 screwdriver.
-
-
-
Remove the motherboard from the tabs and gently lift it out of the case.
-
Remove the yellow NFC module that is attached to the motherboard from the plastic casing with tweezers.
-
-
-
Using a wire stripper, cut the red and black wires attached to the motherboard.
-
-
-
Using a soldering iron, attach the battery to the new motherboard with the red wire connecting to the 0.2 volts (+) and black wire connecting to the ground (-).
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
7 weitere Nutzer:innen haben diese Anleitung absolviert.
12 Kommentare
Hi everyone!
Does anyone know from where I can buy a motherboard for a Beats Pill??
How do I unplug the cord from the battery? I don't want to damage any cords or plugs, Thanks!
Same as akon4konvicted: "Does anyone know from where I can buy a motherboard for a Beats Pill??
While trying to repair I snapped that yellow part with the thin copper running through it, I tried to repair this with superglue but I don't think it worked. Not sure what the part does but is it still safe to use?