Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Find the front face of the camera and test to see of the Lens Barrier will slide.
-
Make sure items are not trapped or stuck between the Lens Barrier and the camera lens.
-
Check to see if the camera power turns on by sliding the barrier. If not check to see if the lens barrier is on the correct track.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Open the camera by removing the 5x4.0 mm external screws with the 1.0 flathead.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Gently pull the top and bottom apart.
-
Make sure the circular spring on the back of the door is intact by manoeuvring the lens barrier and finding the sticking point.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Find the thin, flat orange cable connector that operates the lens barrier and connects it to the main circuit board.
-
Check to make sure the cable is not stuck or broken.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Replace lens cable connector if it is damaged.
-
This last step will require you to solder some of the cable connectors. Click here to learn how to complete this step.
-