Zum Hauptinhalt wechseln

Repariere deine Sachen

Recht auf Reparatur

Store

Einleitung

A Guide to replacing the battery in a GBA Cartridge.

Ersatzteile

  1. Unscrew the screw on the back using a Tri-Point Y0 Screwdriver. Flip the cartridge over and carefully push the front half of the casing down, you can now take the front off and remove the game from the plastic casing. Flip the cartridge over and carefully push the front half of the casing down, you can now take the front off and remove the game from the plastic casing.
    • Unscrew the screw on the back using a Tri-Point Y0 Screwdriver.

    • Flip the cartridge over and carefully push the front half of the casing down, you can now take the front off and remove the game from the plastic casing.

  2. Das Essential Electronics Toolkit

    Die wichtigsten Werkzeuge in unserem kompaktesten Kit.

    Jetzt kaufen

    Das Essential Electronics Toolkit

    Die wichtigsten Werkzeuge in unserem kompaktesten Kit.

    Jetzt kaufen
  3. It is now time to get your soldering iron out. Start off by tinning your soldering iron, then push it down against the one of the solder pads until the solder melts, lift one side of the battery up so it no longer makes contact with the pad. Repeat this step for the other pad to remove the battery completely. Start off by tinning your soldering iron, then push it down against the one of the solder pads until the solder melts, lift one side of the battery up so it no longer makes contact with the pad. Repeat this step for the other pad to remove the battery completely.
    • It is now time to get your soldering iron out.

    • Start off by tinning your soldering iron, then push it down against the one of the solder pads until the solder melts, lift one side of the battery up so it no longer makes contact with the pad. Repeat this step for the other pad to remove the battery completely.

  4. To make things a bit easier you can tin the tabs of the battery. Place the battery on the circuit board (make sure you get the orientation right), put a small blob of solder on your iron and heat up the pad under the battery tab while applying some slight pressure to the tab. Once the battery is in place remove the iron and repeat the step for the other side.
    • To make things a bit easier you can tin the tabs of the battery.

    • Place the battery on the circuit board (make sure you get the orientation right), put a small blob of solder on your iron and heat up the pad under the battery tab while applying some slight pressure to the tab. Once the battery is in place remove the iron and repeat the step for the other side.

    • You can now reassemble the cartridge and check if it works.

Abschluss

To reassemble your device, follow these instructions in reverse order.

8 weitere Nutzer haben diese Anleitung absolviert.

Martin Refseth

Mitglied seit: 28.04.2017

1.954 Reputation

2 Anleitungen geschrieben

Team

Bitfix AS Mitglied von Bitfix AS

Community

2 Mitglieder

8 Anleitungen geschrieben

The battery in the finished example is soldered in backwards. The pads are labeled + or -, the battery is also labeled + or -. You can see the - sign on the battery and the tab attached to that is soldered into the + pad in the finished example.

joeyext - Antwort

That’s is the letter e, it’s part of the branding

Martin Refseth -

Kommentar hinzufügen

Statistik anzeigen:

Letzten 24 Stunden: 41

Letzten 7 Tage: 285

Letzten 30 Tage: 1,068

Insgesamt: 7,969