Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Begin by removing the front cap of the JBL Clip 2 by using the blue plastic opening tool to get in between the creases.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
There will be six 3 mm T8 screws under the cap, remove these six screws. Save
-
If you are not trying to replace the speaker please ignore the two middle 3 mm T8 screws during this procedure.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
The front cover will lift open easily and the components will be visible.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
To completely remove the top portion, disconnect the speaker from the motherboard using the blue plastic opening tool.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
There will be four 3 mm T8 screws holding the motherboard in place, remove these four screws.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Disconnect the three solder points connecting the AUX cord to the motherboard.
-
Remove the AUX cord.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.