Einleitung

Restore sound to your laptop by replacing the speaker.

Remove the following 10 screws securing the lower case to the Air:
  • Remove the following 10 screws securing the lower case to the Air:

    • Six 2.8 mm Phillips screws.

    • Two 3.8 mm Phillips screws.

    • Two 5.4 mm Phillips screws.

Kommentar hinzufügen

Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs. Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.
  • Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.

Kommentar hinzufügen

Disconnect the battery connector by pulling it straight out of its socket.
  • Disconnect the battery connector by pulling it straight out of its socket.

Kommentar hinzufügen

Remove the following nine screws securing the battery to the Air:
  • Remove the following nine screws securing the battery to the Air:

    • Four 2.9 mm Phillips.

    • Four 3.8 mm Phillips.

    • One 7.2 mm Phillips.

Kommentar hinzufügen

MANTA DRIVER KIT
112 bit driver kit $59.99
MANTA DRIVER KIT
112 bit driver kit $59.99
Lift the battery out of the Air.
  • Lift the battery out of the Air.

Kommentar hinzufügen

Remove the following two screws securing the speaker assembly to the upper case.
  • Remove the following two screws securing the speaker assembly to the upper case.

    • One 3 mm Phillips.

    • One 5.8 mm Phillips.

Kommentar hinzufügen

Use a spudger to lift the audio-out connector board off the adhesive that secures it to the hard drive bracket. Disconnect the audio out connector from its socket.
  • Use a spudger to lift the audio-out connector board off the adhesive that secures it to the hard drive bracket.

  • Disconnect the audio out connector from its socket.

Kommentar hinzufügen

Rotate the speaker assembly toward the center of the Air. Use a spudger to pry the speaker cable connector up off the audio board.
  • Rotate the speaker assembly toward the center of the Air.

  • Use a spudger to pry the speaker cable connector up off the audio board.

Kommentar hinzufügen

Use the tip of a spudger to pry the speaker connector up off the audio board.
  • Use the tip of a spudger to pry the speaker connector up off the audio board.

Kommentar hinzufügen

Use the tip of a spudger to separate the audio board from the adhesive securing it to the logic board.
  • Use the tip of a spudger to separate the audio board from the adhesive securing it to the logic board.

Kommentar hinzufügen

Disconnect the audio-out cable by pulling the male end straight away from its socket on the audio board.
  • Disconnect the audio-out cable by pulling the male end straight away from its socket on the audio board.

Kommentar hinzufügen

Speaker assembly remains.
  • Speaker assembly remains.

Kommentar hinzufügen

Schluss

To reassemble your device, follow these instructions in reverse order.

4 weitere Nutzer haben diese Anleitung absolviert.

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 1

Letzte 7 Tage: 18

Letzte 30 Tage: 93

Insgesamt: 18,571