Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
This guide will walk you through the steps to replace the LCD screen for your camera.
Was du brauchst
-
-
Flip the camera upside down (have the side with the buttons facing away from you)
-
Look for the side with the triangle icon with three lines in it, this is the battery door. Add pressure and slide this door slightly until it clicks and pops open.
-
-
-
Once the door clicks, you can open it to reveal the slots holding the memory card and the battery.
-
Focusing on the larger slot, this holds the battery. Push the orange tab away from the slot, this will eject the old battery if one was previously inside.
-
Once this slot is open, you can place the new battery inside.
-
-
-
Remove panel on right side (front view) by removing these two screws. (.196in screws)
-
Remove single screw set underneath panel. (0.083in screw)
-
-
-
-
Remove the two screws attaching the back panel to the body on the left side. (.188in screws)
-
-
-
Remove the two screws holding on the back panel. Then remove the three screws on the A/V Out tab (left side). (.188in screws)
-
Remove tab.
-
-
-
Remove the two screws attaching the front panel to the body on the left side. (.18in screws)
-
-
-
Remove three screws as shown. (Right screw:0.084in, Left screw:0.088in, Middle screw:0.114in)
-
-
-
You can now remove the LCD from the camera body.
-
Insert new LCD and reassemble using the steps in reverse order.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 8-5, Regan Spring 2011 Mitglied von Cal Poly, Team 8-5, Regan Spring 2011
CPSU-REGAN-S11S8G5
4 Mitglieder
10 Anleitungen geschrieben
