Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
Steps for replacing the LCD screen on the back of your camera.
Was du brauchst
-
-
Slide the lock switch to the right so that it is in the unlocked position.
-
Use your finger to slide the battery hatch in the direction of the downward arrow so that the hatch is open.
-
-
-
Open the battery hatch and then the black cover to expose the battery compartment.
-
Remove the battery.
-
-
-
Using the Phillips #00 screwdriver, remove the two 2.8 mm screws located under the hatch.
-
-
-
Use the Phillips #00 screwdriver to remove the three 2.8 mm screws on the bottom of the camera.
-
-
-
-
Use the Phillips #00 screwdriver to remove the two 2.8 mm screws on the side of the camera.
-
-
-
Use your fingers to carefully remove the back casing from the front of the camera.
-
-
-
Place the camera on a flat surface with the front side facing down.
-
Use the spudger to flip up the retaining flap and slide the ribbon cable out of the connector.
-
Hold down on the camera's metal casing with one hand. Using your other hand, remove the back case from the rest of the camera.
-
-
-
Use a spudger to lift the screen ZIF connector tab.
-
Use the back of the spudger to push the ribbon cable free.
-
-
-
Remove the four 2.4 mm Phillips screws as shown in picture.
-
Lift up the LCD screen from the front case.
-
-
-
Desolder the wire connecting the LCD to the motherboard.
-
Solder wires from new LCD screen to the circuit board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.