Einleitung

This motherboard replacement guide applies to the Verizon Samsung Galaxy S4 Mini, model number SCH-I435.

Press and hold the END key to power the phone down.
  • Press and hold the END key to power the phone down.

Kommentar hinzufügen

Remove the back cover of the cell phone using a plastic opening tool.
  • Remove the back cover of the cell phone using a plastic opening tool.

The LEGO Brick Separator (https://www.lego.com/en-us/service/brick...) also works perfectly if you don’t have the iFixit Opening Tool handy.

Håvard Haugen - Antwort

  • Pry the battery out using a plastic opening tool.

Kommentar hinzufügen

  • Using tweezers, remove the SIM card by sliding it towards the bottom of the device.

Kommentar hinzufügen

  • Using a nylon spudger, push through the hole at the top of the memory card holder to slide it out.

Does “slide it out” refer to memory card holder or the memory card itself?

Mikko Rantalainen - Antwort

  • Remove the ten 4.0 mm screws on the back of the phone using the #00 Phillips screwdriver.

Kommentar hinzufügen

  • Starting at the USB port, slide a plastic opening tool around the perimeter of the phone between the rear housing and frame. As you work your way around the edge, you will feel the clips release.

  • Carefully separate the rear housing and the mid-frame to reveal the inside of the phone.

Kommentar hinzufügen

  • Use a pair of tweezers to lift the two charging assembly press fit connectors free.

Kommentar hinzufügen

  • Use the flat end of a nylon spudger to lift the headphone jack press-fit connector up to release the ribbon cable.

Kommentar hinzufügen

  • Use the flat end of a nylon spudger to lift the infrared sensor press-fit connector up to release the ribbon cable.

Kommentar hinzufügen

  • Use the flat end of a nylon spudger to lift the front-facing camera press-fit connector up to release the ribbon cable.

Kommentar hinzufügen

  • Gently lift the motherboard up and partially away from the device.

  • The digitizer ribbon cable is still attached to the underside of the motherboard.

Kommentar hinzufügen

  • Put the flat end of a nylon spudger under the lip of the digitizer press-fit connector and lift up to release the connector and free the motherboard.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Richard Suovanen

Mitglied seit 07.02.2017

9.948 Reputation

10 Anleitungen geschrieben

Team

iFixit Mitglied von iFixit

Community

107 Mitglieder

6.517 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 2

Letzte 7 Tage: 40

Letzte 30 Tage: 161

Insgesamt: 1,399