Einleitung
This guide for the Shark AI Ultra AV2511AE will show the steps needed to replace the vacuum bumper. This replacement is needed when the bumper has debris caught that causes the vacuum to make grinding noises or the vacuum is repeatedly running into the same object.
Was du brauchst
-
-
Orient the device upside-down.
-
Remove the six 8 mm screws from the bumper using a Torx TR9 screwdriver.
-
Remove the bumper.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Utah Tech University, Team 1-3, McMurrin Fall 2023 Mitglied von Utah Tech University, Team 1-3, McMurrin Fall 2023
UTAHTECH-MCMURRIN-F23S1G3
3 Mitglieder
7 Anleitungen geschrieben
