Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
This installation guide allows you to remove the power supply circuit board and power cable.
Was du brauchst
-
-
Remove the five #1 Phillips screws (black, 3/16") attaching the cover to the DVD player.
-
One 3/16" screw on the right side of the DVD player.
-
One 3/16" screw on the left side of the DVD player (directly opposite of other screw).
-
Three 3/16" screws on the back of the DVD player.
-
-
-
Remove the blue tape from the processing board by gently pulling upward.
-
-
-
-
Unscrew the two #1 Phillips screws (silver, 3/16") located on the two edge corners of the processing board.
-
-
-
Orient the DVD player so that you are facing the video and audio jacks.
-
Unscrew the two #1 Phillips screws (silver, 3/16") located on the outside of the DVD player
-
-
-
Unhook the power supply connector from the power supply board by pressing down on the small latch.
-
-
-
Orient the DVD player so the back of the DVD player is opposite of you.
-
Unscrew the two #1 Phillips screws (silver, 3/16") that attach the power supply circuit board to the bottom of the DVD player.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
4 weitere Nutzer:innen haben diese Anleitung absolviert.
2 Kommentare
my sony home theater showing push power protector how to resolve it.
Service center said that we need to change motherboard. plz help me out if you can