Einleitung
If the processor fan stops working, and the system is overheating, Follow this guide to replace it.
Was du brauchst
-
-
There are ten 5mm screws surrounding the edge of the cover.
-
A rubber cap covers the eleventh 5mm screw (in the center).
-
Remove the screws using a Phillips #00 screwdriver.
-
-
-
Pry between the casing and cover using a plastic wedge tool.
-
Use the wedge tool to move along the case & slowly pry it open.
-
The wire for the 12v charging port connects the cover to the casing.
-
-
-
Disconnect this connector from the motherboard to avoid damaging the motherboard or charging port cable.
-
-
-
-
Disconnect the battery.
-
Hold down the power button for ~10 seconds to discharge any stored electricity from the motherboard.
-
-
-
At this point you should be able to:
-
-
-
Plastic wire guides hold the wire in place. Manipulate the wire out from these guides.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Gateway, Team S1-G1, Saknee Spring 2019 Mitglied von Gateway, Team S1-G1, Saknee Spring 2019
GCC-SAKNEE-S19S1G1
4 Mitglieder
5 Anleitungen geschrieben
