Änderungen an Schritt Nr. 3
Bearbeitet von nitrous9200 –
Bearbeitung genehmigt von Andrew Optimus Goldheart
- Vorher
- Nachher
- Unverändert
Schritt-Zeilen
| [* black] Use the flat end of a spudger to pry the thermal sensor board off the adhesive securing it to the hard drive. | |
| [* icon_reminder] If you're replacing your hard drive, transfer this sensor to the same position on the new drive. | |
| - | [* icon_note] Users have reported that without the sensor connected, the fans will run |
| + | [* icon_note] Users have reported that without the sensor connected, the fans will run consistently at maximum speed. |