Was du brauchst
-
-
Remove the following three screws:
-
One shouldered 12.4 mm Phillips.
-
Two 7 mm T10 Torx.
-
-
-
Lift the hard drive slightly and disconnect the hard drive thermal sensor connector.
-
-
-
-
Insert the flat end of a spudger into the gap between the SATA data connector and the hard drive.
-
Twist the spudger to separate the SATA data connector from the hard drive, then disconnect it from the hard drive.
-
Fast fertig!
To reassemble your device, follow these instructions in reverse order.
Abschluss
To reassemble your device, follow these instructions in reverse order.
My model have 3 phillips screws, no torx
Nicolas Varney - Antwort
Same here. No torx. Very easy to do. Not a moderate difficulty at all. As long as you don't rush anything and ease the electronics out. Did I say ease? I meant "tease." Tease the connectors out. Slow and steady. Easy as pie.
airira - Antwort