Einleitung
Prereq only for adhesive strips.
Was du brauchst
-
-
Remove the two 2.1 mm Phillips #00 Phillips screws securing the home button control board to the home button mounting bracket.
-
-
-
Wedge the flat edge of a plastic opening tool in between the right end of the home button control board and the home button mounting bracket.
-
Depress the plastic opening tool downwards to pry the adhesive securing the home button control board from the home button mounting bracket.
-
-
-
-
Lift and remove the home button control board up off the home button mounting bracket.
-
-
-
Use the flat edge of a spudger to scrape the old adhesive off the bottom right corner of the front panel assembly.
-
-
-
Gently place the home button control board on top of the home button mounting bracket.
-
-
-
Insert the two 2.1 mm Phillips #00 Phillips screws back into the home button control board to secure it against the home button mounting bracket.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.