iPhone 4 power Logic Board problem?

Question

iPhone 4

Vierte iPhone Generation. Die Reparatur an sich ist unkompliziert, aber Frontglas und LCD müssen gemeinsam ersetzt werden. GSM mit 8, 16 oder 32 GB Kapazität, Modell A1332 in schwarz und weiß.

2375 Fragen Alle anzeigen

Gauthier @gauthier32416

Rep: 45

2

3

Veröffentlicht: 23. Dez 2012

Einstellungen

iPhone 4 power Logic Board problem?

I got here an iPhone 4 which only boot with a pre-charged battery.

If the battery runs down, I can charge it, but the charge icon don’t go away and it’s impossible to boot.

I replaced the dockconnector an battery twice, but without result. There are also no marks of waterdamage, the device looks fine inside, except 1 thing is damaged (http://img834.imageshack.us/img834/1862/...)

Could this be the cause of the problem? Someone who has got the same problem?

Diese Frage beantworten Ich habe das gleiche Problem

Ist dies eine gute Frage?

Ja Nein

Bewertung -1

3 Kommentare

Strange problem. I don't know if that part could cause problems. If your sure this part is broken you could bridge it. Is your battery connector firmly in place..?

23. Dez 2012 von Jordy

Yes, the battery connector looks fine. Ok, I'll try to bridge the contact points of the broken part.

23. Dez 2012 von Gauthier

Bridging also doesn't work..

24. Dez 2012 von Gauthier

Einen Kommentar hinzufügen

2 Antworten

Strange problem. I don't know if that part could cause problems. If your sure this part is broken you could bridge it. Is your battery connector firmly in place..? — Jordy
Yes, the battery connector looks fine. Ok, I'll try to bridge the contact points of the broken part. — Gauthier

oldturkey03 @oldturkey03 Rep: 782,4 Tsd. 1,1 Tsd. 893 2,3 Tsd. · Answer 1 · 2012-12-24T09:32:09-07:00

Hilfreichste Antwort

oldturkey03 @oldturkey03

Rep: 782,4 Tsd.

1,1 Tsd.

893

2,3 Tsd.

Veröffentlicht: 24. Dez 2012

Einstellungen

Gauthier Top, the part that you showed on the image is a SMD capacitor 27PF 5% NP0-C0G. I do have to say that bridging components is not always a wise choice, if bridging would always work, the components would not be necessary, and the manufacturers could/ would eliminate those. So, you can try and replace it, if you know how to work with very small components and have the right tools. Otherwise you cold get it repaired by a local electronics shop. Hope this helps, good luck.

War diese Antwort hilfreich?

Ja Nein

Bewertung 1

Einen Kommentar hinzufügen