Repariere deine Sachen Community Store

Fünfte Generation des iPhones. Die Reparatur dieses Geräts ist unkompliziert und mithilfe von Schraubendrehern, Hebelwerkzeugen und Geduld zu machen. GSM und CDMA mit 16, 32 oder 64 GB in schwarz oder weiß.

2193 Fragen Alle anzeigen

Einstellungen

iPhone 4s Battery connector missing solder pad 3 pad from the left?

I have an iphone 4s and my battery connector broke while changing the screen I have soldered 3 or 4 back to the logic board. The third solder pad from the left is missing and i read that you can use a single strand cooper wire to bypass the missing solder pad. Where does the bypass wire need to go? I know it needs to go the circuits in from of the connector but which one does it need to be connected to? Sometimes the iphone will load up with the apple boot logo then restart and sometimes it will load up saying the iphone has it 100% percent and other times it will load up saying it has 2% but the fully charged plugged symbol is showing please help

Beantwortet! Antwort anzeigen Ich habe das gleiche Problem

Ist dies eine gute Frage?

Ja Nein
Bewertung 1
Einen Kommentar hinzufügen

3 Antworten

Filtern nach:
Am hilfreichsten Neueste Älteste
Gewählte Lösung

Einstellungen

http://cellenuity.com/wp-content/uploads...

http://www.cyberdocllc.com/new-tested-so...

War diese Antwort hilfreich?

Ja Nein
Bewertung 2

1 Kommentar:

2nd pin goes to 2 places ? So 2 single strand copper wires should work

von

Einen Kommentar hinzufügen

Einstellungen

Courtlandt21, see if the attached image will help. No.3 wire connects to the resistor (labelled as A for you) and capacitor (labelled B for you) and you need to bridge the resistor (A)

Block Image

Hope this helps, good luck.

War diese Antwort hilfreich?

Ja Nein
Bewertung 1

1 Kommentar:

hey, what if the second pad is gone

von

Einen Kommentar hinzufügen

Einstellungen

I know this is old but I am having the same problem, solder pads 2,3 &4 missing from the battery connector

Can you double check your post please Turkey,.. or the schematics at least, in the picture it has pin 4 going to ground but I have just got my hands on some schematics and from my understanding pin 4 goes to C294 aswell as ground

From my understanding I need to make jumpers as pictured in my upload ?

We've spoke before via email, I was asking you for advice, not really done any board work since then, this is the 1st "big job" in a long time, any help much appreciated as always

Update (06/15/2016)

Block Image

forgot to put the picture in

War diese Antwort hilfreich?

Ja Nein
Bewertung 0
Einen Kommentar hinzufügen

Antwort hinzufügen

Courtlandt21 wird auf ewig dankbar sein.
Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 1

Insgesamt: 3,766