Power Button Works, but, Will not sleep/wake display
I did a screen replacement and a flex cable replacement on an iPad 2, CDMA.
In short, the power button will turn on and off the iPad, however, pressing the power button will not put the display to sleep or wake it.
I'm assuming that the square circuitry on the flex cable, between the volume buttons and the board connector controls this and could be bad?
Any suggestions?
Ist dies eine gute Frage?
4 Kommentare
Hey Lurch, long time no see, you've been missed.
von mayer
thanks mayer. glad to be back.
von Country Computer Service
John, good to see you back.
von oldturkey03
Thanks oldturkey03.
Note to all the folks: if mayer or oldturkey03 answers a question with more than two paragraphs, yup, ya better bookmark it! ;)
von Country Computer Service