Repariere deine Sachen Community Store

Apple brachte das verschlankte und aufpolierte iPad Air am 1. November 2013 in den Versionen Space Grau und Silber auf den Markt. Es beinhaltet den A7 Prozessor und kann mit 16, 32, 64 oder 128 GB Speicherkapazität gewählt werden.

577 Fragen Alle anzeigen

Einstellungen

Left Side of LCD has shadows/lines after screen repair?

Hey guys,

I've had this issue once or twice now and basically after replacing the glass on an iPad Air, the left side of the LCD has weird shadows going down the side of it. Not sure what caused it as I'm always very careful throughout the repair (expensive devices!) but just wanted to check with the iFixit community to see if anyone had some insight here.

I did a quick search and read about possible firmware issues, although this seemed to be for a different issue than what I'm having.

I'll try to get a picture uploaded soon.

Thanks for any help!

Diese Frage beantworten Ich habe das gleiche Problem

Ist dies eine gute Frage?

Ja Nein
Bewertung 1
Einen Kommentar hinzufügen

4 Antworten

Filtern nach:
Am hilfreichsten Neueste Älteste
Hilfreichste Antwort

Einstellungen

I also have this issue. Replaced the LCD and the lines/shadows are still present. Any insight would be appreciated.

War diese Antwort hilfreich?

Ja Nein
Bewertung 1
Einen Kommentar hinzufügen

Einstellungen

Hello loosen the screws this puts pressure on the lcd when to tight and can cause shadows hope this helps..

If screen was grand before fitting and there's a problem after its never firmware issues but the repairs fault

War diese Antwort hilfreich?

Ja Nein
Bewertung 0
Einen Kommentar hinzufügen

Einstellungen

I have the same defuse squarish pattern up the entire left side. I sent it back thinking it was a manufactures defect only to have a replacement one do the same thing. It has no pressure behind it. It's not even screwed down. Appreciate any help.

War diese Antwort hilfreich?

Ja Nein
Bewertung 0
Einen Kommentar hinzufügen

Einstellungen

Had the same issue, also still present when the screws were not secured. I was thinking it could have been the connector ribbon as I pulled the edge up a bit when trying to take the connector plate off it (I didn't rip the connector but it just pealed at bit from the connection piece), but not certain.

War diese Antwort hilfreich?

Ja Nein
Bewertung 0
Einen Kommentar hinzufügen

Antwort hinzufügen

jon wird auf ewig dankbar sein.
Seitenaufrufe:

Letzte 24 Stunden: 1

Letzte 7 Tage: 3

Letzte 30 Tage: 13

Insgesamt: 1,712