Rep: 13
1
Navibot sr8855 after repair of FET tranzistors for brush have bad mooving - navigation.
From the beginning it worked well and after some time was problem in navigation.
It looks like that: move 20-30cm stop and go back about 3cm, turn 90st. and repeat.
Sometimes work good for 1 minute and then again fail to this state.
I try test mod and all sensors look fine, motors are OK too.
Ist dies eine gute Frage?
Rep: 13
1
Hi,
yes, i found that it was dusturbation in system . I add some capacitors on motor and all is OK
War diese Antwort hilfreich?
Can you describe more precise what did you done?
Could be the aging of the accumulator?
War diese Antwort hilfreich?
Rep: 13
1
I must replace suction motor and with it start the disturbance of electronics. For this I used capacitors on motor pads. I was 1nF + 100nF + 1uF together. To other motors must be carefull becouse are PWM drivered. There You can use only some smaller - max 100nF capacitors.
War diese Antwort hilfreich?
Hi
What voltage do you use in capacitors?
Can be that the battery started to decay?
War diese Antwort hilfreich?
Rep: 13
1
It could probably have an effect but it is not a reason.
War diese Antwort hilfreich?
Letzte 24 Stunden: 0
Letzte 7 Tage: 0
Letzte 30 Tage: 5
Insgesamt: 1,931
I have the same issue. Is there a fix?
von mirceaghita