Repariere deine Sachen Community Store

Das iPhone 6 mit dem 4,7 Zoll Display ist die kleinere Version des iPhone 6 Plus und kam am 19. September 2014 auf dem Markt. Es hat die Modelnnummern A1549, A1586 und A1589.

4994 Fragen Alle anzeigen

Einstellungen

No backlight after unlock phone (backlight work during boot)

Hi guys,

recently i repaired iPhone 6 water damaged.

I replaced PMIC, after then phone boot but there are not backlight and touch. I replaced:

- backlight IC

- backlight capacitors

- touch ICs - MESON, CUMULUS

- LCD IC - CHESTNUT

Now after press power button, phone boot with backlight and work normal. When i lock phone, LCD goes off, but when i want unlock phone there are not backlight. Touch and LCD work.

My question is:

Where can be problem? It look, backlight driver do not receive ENABLE signal after booting and do not want work.

Can be here problem with

45_AP_TO_PMU_AND_BL_DWI_CLK

45_AP_TO_PMU_AND_BL_DWI_DO

?

For what is there this bus?

Sorry for my bad english :)

Thanks

@refectio

Beantwortet! Antwort anzeigen Ich habe das gleiche Problem

Ist dies eine gute Frage?

Ja Nein
Bewertung 0
Einen Kommentar hinzufügen

2 Antworten

Filtern nach:
Am hilfreichsten Neueste Älteste
Gewählte Lösung

Einstellungen

Those two lines are part of the I2C bus. You will want to check them to insure they are not shorted. I would also look at pin B1 of U1502. That is the Hardware Enable pin. I don't know enough about the internal logic of these IC's to say what could be causing this.

War diese Antwort hilfreich?

Ja Nein
Bewertung 2
Einen Kommentar hinzufügen

Einstellungen

I fixed so many backlights specially on 6 and 6s. Normally it's filter

But recently I d given iPhone 6s with very low backlight

Checked all caps, filter, diod, coil etc. Everything seemed fine so I changed backlight ic(u2040) no luck

And than I changed main pm ic and problem has gone.

War diese Antwort hilfreich?

Ja Nein
Bewertung 1

2 Kommentare:

How do you know that you must replace PMIC? Should i use multimeter?

von

yes check all the voltage and most importantly recistance of the components.

But you said you have changed it didn't you?

But again your phone is the water damage. Could be anything man.

Have you checked any short?

von

Einen Kommentar hinzufügen

Antwort hinzufügen

Tomas wird auf ewig dankbar sein.
Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 3

Letzte 30 Tage: 7

Insgesamt: 481