Rep: 121
2
2
1
Yesterday I received shell replacements for my Nintendo switch joy cons. I changed the shell on my left joy con and it works like normal, but when i changed the shell on my right joy con it now only works when it is directly connected to the switch. The second i undock the jot con it dies. Please help
Ist dies eine gute Frage?
Rep: 49
1
Most likely, your battery is unplugged or a ribbon cable is lose.
1)Unplug and replug your battery . Now see if it works.
2) Check the joycon rail cables (black sliding latch thing)
These two cables seem to have these properties:
A) This cable is for SL/SR/sync fixing I believe this is needed to Connect Wirelessly
B) this cable comes from the bottom part of the slider where the 'teeth' are on the joycon. This cable seems to be responsible for: Charging and Connecting to the System in Handheld mode
Unplug, replug A first, see if it works, then try B.
Good luck!
War diese Antwort hilfreich?
Rep: 4,3 Tsd.
10
5
7
I’ve seen this issue before. More than likely the battery was not hooked up properly or the wire running from the battery to the motherboard was damaged. The connector for the battery to the motherboard is rather difficult to disconnected and you could have pulled too hard in the wrong direction causing the wire to be damaged.
It is very important to always use a non-conductive tool when working with a battery to save the possibility of ruining it. Use a plastic Spudger tool for all batteries.
Here is a link to a new battery for the Joy-Con Nintendo Switch Joy-Con Controller Battery
War diese Antwort hilfreich?
Could he not see if this was the issue by plugging in another joycons battery into his non working one?
Hi, exactly the same issue, joycon only works attached. When out of the console, no lights and no syncing. Battery works fine in right joycon. When attached to the console, it shows no battery level. It seems joycon motherboard not receiveng battery...
I have the same issue as Ciberajj Juas - low/red battery, no charging symbol when connected directly, no lights, no syncing when disconnected.
Rep: 43
2
have you tried chargeing with 3party carger instead on Nintendo switch
War diese Antwort hilfreich?
Rep: 300
4
This is somebody’s same problem with OLED. And what’s this? Jot Con? Change it!
War diese Antwort hilfreich?
Letzte 24 Stunden: 2
Letzte 7 Tage: 14
Letzte 30 Tage: 105
Insgesamt: 16,599
1 Kommentar
I didn't do anything to my joy cons and they both only work when attached to the Switch directly
von Greg.