Rep: 21
1
2
I have a Nintendo switch that has a broken port I bought the tools and equipment for it and have set the temperature on my hot air rework station set to 350c but no luck and I even tried putting flux but still nothing, I don't know if I am giving it enough heat or I am missing something, I am a newbie when it comes to this stuff, any help would be greatly appreciated, thank you.
Ist dies eine gute Frage?
Rep: 159,7 Tsd.
11
191
368
The Type-C port requires a lot of heat to remove. Have you added leaded solder on the charging port pins to lower the melting point of the solder?
Leaded solder has a lower melting point compared to non-leaded solder which will be what the components on the logic board are soldered with.
Check out this video for reference:
https://www.youtube.com/watch?v=Wfx3ShJC...
A board preheater (This helps a lot) is used along with a soldering iron and a hot air gun at the same time to remove the type-C port.
War diese Antwort hilfreich?
Letzte 24 Stunden: 1
Letzte 7 Tage: 4
Letzte 30 Tage: 27
Insgesamt: 2,937
1 Kommentar
I have the same issue but I was able to get it off but there is old solder left in the four holes and it is preventing the port from sitting flush
von killiandw