Repariere deine Sachen Community Store

Die Wi-Fi Version von Apples iPad 6, erschienen im März 2018. Erhältlich mit 32 und 128 GB Speicher. Ausgestattet mit einem 9,7" Retina Display und einem 64-bit A10 Fusion Prozessor.

151 Fragen Alle anzeigen

Einstellungen

Unresponsive band in screen after digitizer replacement

I just performed a digitizer swap on a very badly cracked iPad 6th gen. After reassembling everything, I crossed my fingers and cheered as it turned on, then again after I found the touch screen was responsive. However, upon trying to enter my passcode, I realized that there is a horizontal band across the screen that does not recognize any touch, infuriatingly in the same place as the top row of numbers. How do I fix this?

Diese Frage beantworten Ich habe das gleiche Problem

Ist dies eine gute Frage?

Ja Nein
Bewertung 0
Einen Kommentar hinzufügen

1 Antwort

Filtern nach:
Am hilfreichsten Neueste Älteste

Einstellungen

hello Joel,

unfortunately, it is often talked about. There are many reasons why touch after replacement does not work partially. Most often it is a badly positioned connector in the proper port. The connection is mechanical and sometimes fails. Clean them and make sure all copper pins are in place. The second common reason is that the digitizer was damaged at the factory or during assembly. Of the 100 bought, over 15% are often damaged, while damage during assembly occurs on the edges of the signal tapes, along the main paths - at the edge of the contact with the housing. A abrasion is enough to turn off the entire section. Good luck.

  • regards,

War diese Antwort hilfreich?

Ja Nein
Bewertung 0
Einen Kommentar hinzufügen

Antwort hinzufügen

Joel O. wird auf ewig dankbar sein.
Seitenaufrufe:

Letzte 24 Stunden: 1

Letzte 7 Tage: 2

Letzte 30 Tage: 11

Insgesamt: 291