Rep: 1,5 Tsd.
2
4
I have a Vaio VGN-CR490E whose HDD I want to replace with an SSD, but one of the screws that holds the drive in the bracket is stripped.
One of the screws on the inside is stripped as well.
For large stripped screws I’ve heard you can unscrew them if you put a rubber band between the screw and the screwdriver, but that doesn’t seem to work for these smaller screws. Does anyone know of anything I can do?
Ist dies eine gute Frage?
Rep: 28,4 Tsd.
9
13
64
Jeweller supply houses supply small screw extractors. For these the pilot hole must be perfectly centred and perpendicular. In my experience, a quality, correct sized screw driver, well supported work and sufficient pressure will remove the screw. Holding it perfectly perpendicular to the screw is very important and be very mindful of possible slipping so you wont injure yourself or damage the laptop. Take your time and carefully think out each step.
If you have access to a drill press put the screw driver head in the chuck and using it manully (no electricity) to turn the screw driver along with the drill press’s down lever the torque will be sufficient.
In your case taking the drive and it’s caddy right out of the laptop will make all this much easier. If it is possible take out the other three screws and see if you can wiggle the drive a little bit. This can often be just enough to slightly loosen the screw. Good luck. Let us know how it goes.
For others here is Sony’s pdf of the general removal of the hard drive:
War diese Antwort hilfreich?
Letzte 24 Stunden: 2
Letzte 7 Tage: 2
Letzte 30 Tage: 9
Insgesamt: 287
