Einstellungen

Black screen after replacing flex cable. [SOLVED]

[THE PROBLEM]

I ran into an issue in the shop where after replacing the Flex cable every screen I tried was black. The iPod wouldn't even beep when plugged in.

Since I googled the tar for a solution, and couldn,' find one, I'll post what I found for anyone else with the same problem who hasn't been able to find a solution.

The solution is moved below, to the answer so that it can be cleared per request.

Beantwortet! Antwort anzeigen Ich habe das gleiche Problem

Ist dies eine gute Frage?

Ja Nein

Bewertung 2

2 Kommentare

Please use the last paragraph as an answer and accept it to clear the question.

15. Mär 2012 von rj713

Thanks for letting me know guys, I did as you suggested.

19. Mär 2012 von Country Computer Service

Einen Kommentar hinzufügen

Veröffentlicht: 19. Mär 2012

Einstellungen

[HOW TO FIX IT]

I covered the circuits around the flex cable and de-solder it then cleaned up the pads and soldered on the new flex.

Not adhering to my own soldering instructions, of course I got in a rush and did this without de-soldering the + terminal on the battery first.

In my case, I went back and disconnected the + terminal on the battery and soldered it back on. The black screen went away and the iPod kicks up just fine.

I hope this helps fellow techs that may have found this.

War diese Antwort hilfreich?

Ja Nein

Bewertung 3

Einen Kommentar hinzufügen

iPod Touch 4th Generation

Black screen after replacing flex cable. [SOLVED]

1 Antwort

Antwort hinzufügen