accepts disc but stays on load will not play
Samsung p231 dvd player accepts the disc and the door closes but the indicator window shows loading and will not start playing
Ansicht:
Bestätigte AbstimmungenJeder mit mehr als 20 Reputationspunkten kann problematische Kommentare und Beiträge melden.
Details anzeigen
Rep: 409
Veröffentlicht:
Samsung p231 dvd player accepts the disc and the door closes but the indicator window shows loading and will not start playing
Rep: 223
Veröffentlicht:
I am afraid I am not familiar with the Samsung model in particular so I will give you a few general tips that may get you going.
1- Make sure you hear the spindle motor spinning the disk to an even speed.
If it seems to be speeding up and slowing down you could have a dirty/bad optical pick up assembly.
2-Try with different DVD/ CD to isolate.
Many times it is just the disk is dirty scratched and the player cannot reliably read information from disk.
3-Look for signs of lubricant/dirt on/under the player tray or on disk.
I have had optical drive mechanisms spit lubricant and have left an oily film on the pick up unit causing this.
4-Clean the pick up unit.
Be very careful with this one as some units are mounted on very flimsy suspension/positioning mechanisms that will break if you look at them cross-eyed.
5-Re-seat all the connections inside.
A loose SATA or Data cable may be all that is stopping the information from the disk from getting to the circuit board.
6-Swap the drive with a known good one.
Many set-top DVD players use Laptop or PC sized drives with the same connections. I have fixed a couple of Sony set-top players with drives from broken Sony laptops.
Hope this at least guides you to a possible solution.
Ups! Ich will meine Meinung nochmal ändern.
Erweitern / Reduzieren
Bestätigen
Positiv
Ablehnen
Negativ
Hilfe öffnen
Seite 1 von 1