Canon EOS 60D USB Replacement connector

1. Schritt — Exchange of the connecter card

Also look at the pdf file or I have some photos that could not be deposited in this tutorial

2. Schritt — View of the defect

Seen from the broken socket, the central part almost no longer holds and goes wrong

3. Schritt — Or buy the replacement card

After a long search, I was able to find the famous map on the Aliexpress website

4. Schritt — tools required

Screwdrivers #00

5. Schritt

- For the disassembly of the complete plastics of the device, Proceed according to this very good video:

6. Schritt — Following the links

- Video #7, Repairing The Set Button And Control Dial https://youtu.be/zaJJqRCfYXc - Video #8, Testing The Power Board https://youtu.be/yeCrpv_u1Zw

7. Schritt — Location of the screws to be removed

Download this page DIagram #1: http://www.thebobfactor.com/Canon%206... - Print the - You have the position of all the screws and at each screw disassembled, glue it with a small tape tape, which will allow you to know or put it back to rewind

8. Schritt — Trick

Small tip, to avoid losing the screws I put a magnet so that the screws are "glued" to the screwdriver

9. Schritt — After the operations described in the video

Once this video has been dismantled, you must see this

10. Schritt — Unbuttoning connecters and removal of screws

There are 5 screws left to loosen and 6 connecters to unbutton

11. Schritt — Removal of connectors

Remove the two cables from these two connecters, as well as the screw on the right

12. Schritt — Removal of the screws

3 screws to remove, one of which is hidden under the yellow tape

13. Schritt — Screw removal

Remove the last screw

14. Schritt — Ribbon connecter

Detach the tablecloth by pulling underneath with a flat screwdriver or with an unfolded paper clip in the hole provided for this purpose

15. Schritt — Clear the card

This is the most delicate part to gently clear the card by moving it without forcing it, until it finds its pivot point

16. Schritt — Video connecter removal

The connecter undoes very easily by levering on each side of the golden connecter

17. Schritt — Card withdrawn

Exchange the deposited card

18. Schritt — Reassembly of the card

Put the golden connecter back on, a slight pressure is enough

19. Schritt — Identification of the card centring picot

We see where the plastic pin is located that holds the printed circuit board, next to the screw hole

20. Schritt — Rest from the map

Reinsert the tablecloth into its connecter, without forcing, the hole of the tablecloth must be in the plastic pin to be in place

21. Schritt — Installation of the cables

Be careful, the screw on the side comes to the arrowhead, the other hole must remain free for the screw of the plastic case (I was wrong)

22. Schritt — Reassembly of plastics

Proceeding with the opposite of the video, everything went well.

23. Schritt

Use 3M spray mount glue to glue the rubber sheath on the case