Repariere deine Sachen Community Store

微软 Surface Pro 6 打开机壳程序

Hinweis: Du bearbeitest eine grundständige Anleitung. Alle Änderungen, die du vornimmst, betreffen alle 13 Anleitungen, die diese beinhalten.

Zurück zur Anleitung
Englisch
Chinesisch
Nächster Schritt

Schritt 1 übersetzen

Schritt 1
Microsoft Surface Pro 6 Opening Procedure, Heat the screen: Schritt 0, Bild 1 von 1
Heat the screen

  • Completely power off the Surface before you begin disassembly.

  • If the screen's glass is cracked, keep further breakage contained and prevent bodily harm during your repair by taping over the glass. Lay overlapping strips of clear packing tape over the display until all the glass is covered. Wear safety glasses to protect your eyes.

  • Heat an iOpener and apply it to the right edge of the Surface's screen for two minutes.

  • You may need to reheat and reapply the iOpener several times to get the Surface warm enough. Follow the iOpener instructions to avoid overheating.

  • A hair dryer, heat gun, or hot plate may also be used for more heat, but be careful not to overheat the Surface—the screen and internal battery are susceptible to heat damage.

加热屏幕

在开始拆卸之前完全关闭 Surface 电源。

如果屏幕玻璃破裂，请用胶带粘住玻璃，以防止进一步破裂，并防止在维修过程中对身体造成伤害。在显示屏上重叠粘贴透明胶带，直至覆盖所有玻璃。戴上安全眼镜保护眼睛。

加热 iOpener并将其应用到 Surface 屏幕的右边缘两分钟。

你可能需要多次重新加热并重新涂抹 iOpener，以使 Surface 足够温暖。按照 iOpener 说明操作以避免过热。

也可以使用吹风机、热风枪或热板来增加热量，但请注意不要使 Surface 过热 —— 屏幕和内部电池容易受到热损坏。

Deine Beiträge sind lizenziert unter der Open-Source Creative Commons Lizenz.