Zum Hauptinhalt wechseln

基本的なLED懐中電灯のDIYはんだ付けキットの組み立て

Englisch
Japanisch
Schritt 6
Basic LED Flashlight DIY Soldering Kit Assembly, Bend the resistor leads: Schritt 0, Bild 1 von 3 Basic LED Flashlight DIY Soldering Kit Assembly, Bend the resistor leads: Schritt 0, Bild 2 von 3 Basic LED Flashlight DIY Soldering Kit Assembly, Bend the resistor leads: Schritt 0, Bild 3 von 3
Bend the resistor leads
  • Hold the resistor flush against the front of the circuit board.

  • Flip the board over.

  • Bend the resistor leads until they're parallel to the circuit board. This will keep the resistor still while you solder it to the board.

抵抗器を回路基板の前面にぴったりと当てる。

基板を裏返す。

抵抗器のリード線を基板と平行になるまで曲げる。これにより、基板に半田付けする際に抵抗器が動かないように固定できる。

Deine Beiträge sind lizenziert unter der Open-Source Creative Commons Lizenz.